_florent_ changed the topic of #litex to: LiteX FPGA SoC builder and Cores / Github : https://github.com/enjoy-digital, https://github.com/litex-hub / Logs: https://libera.irclog.whitequark.org/litex
tpb has quit [Remote host closed the connection]
tpb has joined #litex
Degi_ has joined #litex
Degi has quit [Ping timeout: 268 seconds]
Degi_ is now known as Degi
FabM has joined #litex
FabM has joined #litex
FabM has quit [Changing host]
TMM_ has quit [Quit: https://quassel-irc.org - Chat comfortably. Anywhere.]
TMM_ has joined #litex
cr1901_ has joined #litex
cr1901 has quit [Ping timeout: 244 seconds]
indy has quit [Quit: ZNC 1.8.2 - https://znc.in]
indy has joined #litex
shorne has quit [Read error: Connection reset by peer]
shorne has joined #litex
indy has quit [Ping timeout: 244 seconds]
indy has joined #litex
geertu has quit [Ping timeout: 256 seconds]
geertu has joined #litex
cr1901_ is now known as cr1901
esteves has joined #litex
<esteves> Hi everyone, can some
<esteves> someone*, help me with using GDB w/ the VexRiscv CPU?
<esteves> I was following the guide "Use-GDB-with-VexRiscv-CPU" but openocd doesn't show the last two lines: "Info : Listening on port 6666 for tcl connections
<esteves> Info : Listening on port 4444 for telnet connections"
<esteves> The only difference is that I'm not using the Digilent Arty board. There's some parameter that should change? When starting openocd?
<esteves> nevermind, I found the problem
<esteves> thanks
esteves has quit [Quit: Client closed]
indy has quit [Ping timeout: 272 seconds]
indy has joined #litex
TMM_ has quit [Quit: https://quassel-irc.org - Chat comfortably. Anywhere.]
TMM_ has joined #litex
FabM has quit [Quit: Leaving]