_florent_ changed the topic of #litex to: LiteX FPGA SoC builder and Cores / Github : https://github.com/enjoy-digital, https://github.com/litex-hub / Logs: https://libera.irclog.whitequark.org/litex
tpb has quit [Remote host closed the connection]
tpb has joined #litex
peeps[zen] has joined #litex
peepsalot has quit [Ping timeout: 252 seconds]
alainlou has joined #litex
Degi_ has joined #litex
Degi has quit [Ping timeout: 265 seconds]
Degi_ is now known as Degi
FabM has joined #litex
FabM has joined #litex
TMM_ has quit [Quit: https://quassel-irc.org - Chat comfortably. Anywhere.]
TMM_ has joined #litex
Martoni42 has joined #litex
Martoni42 has quit [Ping timeout: 252 seconds]
nickoe has quit [Ping timeout: 268 seconds]
nickoe has joined #litex
peeps[zen] is now known as peepsalot
nthiel has joined #litex
peeps[zen] has joined #litex
peepsalot has quit [Killed (NickServ (GHOST command used by peeps[zen]))]
peeps[zen] is now known as peepsalot
alainlou has quit [Quit: Client closed]
nthiel has quit []
TMM_ has quit [Quit: https://quassel-irc.org - Chat comfortably. Anywhere.]
TMM_ has joined #litex
Melkhior has quit [Read error: Connection reset by peer]
Melkhior has joined #litex
michalsieron has joined #litex
michalsieron has quit [Ping timeout: 260 seconds]
FabM has quit [Quit: Leaving]
Martoni42 has joined #litex
Martoni42 has quit [Ping timeout: 268 seconds]
<mm001> i continued to try to find out. When I build the linsn_rv901t.py, it doesn't crash on udp packet (obviously, i hope).
<mm001> I still did not find out how to change rgmii_test.py so that I can send an udp packet without the board crashing...
<mm001> I try to understand the differences. There's the sys_clk_freq (133 MHz in rgmii_test.py and 75 MHz in linsn_rv901t.py). There's RAM initialized in linsn_rv901t.py.
<mm001> I need some sleep :-) Will try again next week.
peepsalot has quit [Ping timeout: 252 seconds]
peepsalot has joined #litex