ikarso has quit [Quit: Connection closed for inactivity]
ft has quit [Ping timeout: 268 seconds]
ft has joined #beagle
Shadyman has joined #beagle
starblue has quit [Ping timeout: 256 seconds]
starblue has joined #beagle
CygniX has joined #beagle
lucascastro has quit [Ping timeout: 246 seconds]
<set_>
The motor cape can handle 3A! I just realized it by r-e-a-d-i-n-g.
<set_>
Yes...new momentum!
<set_>
Why was, and yes I understand there is nine minutes left in this era of questioning, the Motor Cape taken out of rotation in the DTBO files available under all the DTS available?
<set_>
I am asking for me. u-boot offerings never picked it up and somehow it slipped through protocol...
buzzmarshall has quit [Quit: Konversation terminated!]
renrelkha has quit [Quit: bye]
renrelkha has joined #beagle
mvaittin has joined #beagle
<set_>
The Cape works!
<set_>
For some reason, the Motor Cape does not work w/ PWM on stepper motors.
<set_>
I read about putting the duty_cycle low to push the stepper.
<set_>
It just does not work w/ this Cape. If the motor terminals were all GPIO, I can get at it.
<set_>
But...that is not how the Cape works.
ikarso has joined #beagle
jfsimon1981 is now known as jfsimon
mvaittin has quit [Read error: Connection reset by peer]
Shadyman has quit [Quit: Leaving.]
<set_>
Is there a way to make all terminal outputs GPIO on the Motor Cape?
<samael>
i have an old bbb rev5c from beagleboard.org (can't say exactly how old, around 2018 probably). tried to flash an image via uSD to eMMC using "BeagleBoard.org Debian Bookworm Minimal Image 2023-10-07" system image, kernel 5.10.168-ti-r73 but the eMMC is not seen by the system. `fdisk -l` only shows the uSD. indeed, the eMMC is working well because the old system (BeagleBoard.org Debian Image
<samael>
2018-10-14, kernel 4.14.71-ti-r80, stretch) boots up without any trouble if i remove the uSD from the slot. any hint?
<samael>
oh, and i do have disable_uboot_overlay_emmc=1 commented out in uEnv.txt. this uSD is used as flasher image, i used it without any problem several times on other BBBs. only had this weird trouble on this very BBB so far.
jfsimon has quit [Remote host closed the connection]
russ has quit [Ping timeout: 260 seconds]
russ has joined #beagle
lucascastro has joined #beagle
buzzmarshall has joined #beagle
buzzmarshall has quit [Quit: Konversation terminated!]
jfsimon1981 has joined #beagle
vagrantc has joined #beagle
lucascastro has quit [Read error: Connection reset by peer]