03:59 <tekkamanninja> good morning

07:23 <rwmjones> morning

10:59 <davidlt[m]> rwmjones: could you check if your boards are all OK? Seems OK, just one to make sure no strange things are on dmesg/console before building opensbi/u-boot/kernel (yes, it's time to do some updates!).

11:41 <rwmjones> davidlt[m]: one sec

11:43 <rwmjones> davidlt[m]: I'm going to reboot them all, they don't look good, is that ok?

11:50 <rwmjones> davidlt[m]: should be good now

11:51 <davidlt[m]> rwmjones: yeah, it's OK. I haven't started anything.

11:52 <davidlt[m]> rwmjones: btw, I already released 14 servers back to GCC Compile Farm. Probably will get their OpenStack account this or the next week.

11:54 <rwmjones> davidlt[m]: when will you start the builds? I may need to reboot five & jive again to fix the fan on jive which is grinding

11:55 <davidlt[m]> rwmjones: most likely later today or tomorrow

11:56 <davidlt[m]> rwmjones: just tell me when I can send the koji job and that's fine

11:58 <davidlt[m]> Mainly I want to get opensbi (Anup is pulling in some patches right now) + u-boot (2022.07-rcX to get some PCIe fixes for Unmatched) + kernel 5.18.X (does incl. PCIe and DT fixes for Unmatched, incl. full PMIC enablement).

11:58 <rwmjones> just that I have to give a talk in a couple of hours, so if was started now + 4 hours that'd be better

11:58 <davidlt[m]> Just a new image before I destroy everything.

11:58 <rwmjones> (it started grinding when I rebooted)

11:58 <davidlt[m]> rip those fans off, just use standard 120mm or 140mm fans with some stand offs

11:59 <rwmjones> on the same topic, would love to take these two machines _out_ of rotation, and use the two unmatched machines instead

11:59 <davidlt[m]> I bought some 40, 45, 50 mm hex standoffs and I love them

11:59 <davidlt[m]> Yeah, so this update would be exactly for that.

11:59 <davidlt[m]> Maybe to bring those PCIe fixes within the kernel and u-boot

12:00 <rwmjones> can you do the builds now + 4 hours, and I'll make sure they're booted up before then?

12:00 <davidlt[m]> But there are gazillions of more fixes since the last image, thus 5.18.X

12:00 <davidlt[m]> I will wait

12:00 <rwmjones> ok thanks

12:00 <davidlt[m]> Just ping me once all is good to go

12:00 <rwmjones> I'm going to power them off now, but I'll power them back up after 4.30pm here (after the talk)

12:01 <rwmjones> and I'll ping you

12:01 <davidlt[m]> Or just power them down now and I will see in Koji once they are back online

12:02 <rwmjones> I've written myself a post-it note

12:02 <rwmjones> ok back to the talk prep ...

12:06 <davidlt[m]> I reached new level in my life: used a nail scissors to short pins on SPI flash on my PineBook Pro (arm64 laptop) to get it into maskrom mode after I wrote new firmware to a wrong offset to save it :)

12:07 <davidlt[m]> That DIP switch on Unleashed/Unmatched to use microSD card is way more convenient to recover :)

12:13 <sharkcz> hehe, I used a SOIC-8 clip over the flash plus a jumper wire, I had exactly the same problem :-)

14:48 <rwmjones> davidlt[m]: bring both boards up right now, will be a few mins

14:49 <davidlt[m]> rwmjones: ok

14:50 <rwmjones> davidlt[m]: just wait a min til I ping you that they're ready, because i might need to restart kojid

14:54 <rwmjones> davidlt[m]: ok, should be all good now