00:37 <zmatt> rah: I guess your kernel doesn't have CONFIG_SERIAL_8250_OMAP_TTYO_FIXUP enabled?

00:59 <set_> New person here, does anyone know the enable pin/GPIO on the BBAI-64 for the Servo Cape off hand?

01:00 <set_> I need to research but I am getting odd results so far...

01:02 <set_> GPIO0_16!

01:03 <set_> That blurt was for the Servo Cape users!

01:05 <set_> Does the AI64 work like the am335x/BBB boards in that I use 0 * 32 + 16 = MY_PIN?

01:06 <set_> Probably not, heh?

01:34 <set_> Does this mean... line 16: "P8_10" "pca9685-enable" output active-high [used] ...that I need to do nothing and it is already active-high?

02:04 <set_> Whelp... I think I got it but the server does not run. Argh.

03:30 <set_> The docs are looking good for the edgeai_ stuff.

03:42 <set_> Oh! I see where I made the mistake now. 1_16 and not 0_16. 1_16 is the gpiod config type while 0_16 is the way to mux the pin in am335x ideas w/ the BBB and the config-pin utility or w/ echo'ing GPIO devices...pre gpiod.

03:42 <set_> Sheesh.

12:22 <rah> zmatt: no idea, it's Debian's kernel

12:31 <rah> and, it would appear that the second network interface doesn't work in Debian's kernel either

12:31 <rah> the kernel has created an eth1 interface but the link doesn't come up

15:30 <zmatt> rah: "no idea" -> I mean, you can just check... grep CONFIG_SERIAL_8250_OMAP_TTYO_FIXUP /boot/config-$(uname -r)

17:29 <Dyslexicbloke> Hi folks, can somone tell me which board is best to use as a Node Red host... Preferably one with an SD interface so I can load it easily?

18:15 <set_> Yes.

18:15 <set_> I can tell...