00:00 <KevinP> zmatt, thank you for the information.

00:15 <KevinP> zmatt: is this what you where referring to:

00:15 <KevinP> &mmc1 {

00:15 <KevinP>         status = "okay";

00:15 <KevinP>         vmmc-supply = <&vmmcsd_fixed>;

00:15 <KevinP>         bus-width = <4>;

00:15 <KevinP>         pinctrl-names = "default";

00:15 <KevinP>         pinctrl-0 = <&mmc0_pins>;

00:15 <KevinP>         cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;

00:15 <KevinP> };

01:21 <zmatt> please don't paste multi-line stuff into chat, it's spammy

01:22 <zmatt> I don't really understand why you pasted the entire definition of this node, I'm just referring to the fact that it's labeled mmc1 rather than mmc0 (and similarly mmc1 is labeled mmc2, etc)

01:23 <zmatt> or rather you pasted some dts file's additional properties for this node, which is even more mysterious

01:24 <zmatt> so, no, I'm not referring to anything in what you pasted other than the label of the node

02:06 <set_> @zmatt: How did you know about the 4A continuous from the PWR pins on the Servo Headers on the BBBlue?

02:07 <set_> Does it have to do w/ the regulator, extra circuitry, and/or both regulator and circuitry?

02:26 <set_> I see it says it...4A.

02:30 <set_> peak is 6A at typical while 5A is the normal peak current.

02:31 <set_> So, no flatlines. Got it.

02:33 <set_> So, you guys were going for effeciency?

02:36 <set_> I will call the docs. at 4A and see if anyone gestures towards BS. Factors!

23:19 <XoUoX> Hello, is there anyone that could point me the right direction? :)

23:21 <XoUoX> I have made expansion board with codec for beaglebone AI, but I am unable to gen any audio output form it (except loopback)