GNUmoon has quit [Remote host closed the connection]
GNUmoon has joined #litex
genpaku has quit [Read error: Connection reset by peer]
genpaku has joined #litex
Guest3695 has joined #litex
Guest3695 is now known as blub
blub is now known as blub74
blub74 has quit [Quit: Client closed]
blub74 has joined #litex
blub74 has quit [Client Quit]
blub74 has joined #litex
<blub74>
I ran ./make.py --board=acorn_pcie --flash using an ft2232h adapter and SQRL_quickstart. Both doing ./litepcie_util info and ./litepcie_util scratch_test show up ok. Only the errors column of ./litepcie_util dma_test shows a lot of errors (e.g. about 42467328 and varying but never 0). litex_term /dev/ttyLXU0 gives me a properly working console. To
<blub74>
upload litex_term /dev/ttyLXU0 --images=images/boot.json I have to add --safe to painfully slow upload the images. Can anyone point me in the right direction to reduce dma_test erros to zero? Thanks!
blub7476 has joined #litex
blub7476 has quit [Client Quit]
blub74 has quit [Quit: Client closed]
blub74 has joined #litex
blub74 has quit [Quit: Client closed]
shorne has quit [Read error: Connection reset by peer]
shorne has joined #litex
Joel30 has joined #litex
Joel30 has quit [Quit: Client closed]
meks has joined #litex
meks has quit [Client Quit]
pbsds6 has joined #litex
pbsds has quit [Ping timeout: 250 seconds]
pbsds6 is now known as pbsds
shorne has quit [Read error: Connection reset by peer]