azonenberg changed the topic of #scopehal to: libscopehal, libscopeprotocols, and glscopeclient development and testing | https://github.com/glscopeclient/scopehal-apps | Logs: https://libera.irclog.whitequark.org/scopehal
<t4nk_freenode> think that's a nice starting point... have some decent stable connections, at least won't have to worry about that
balrog has quit [Quit: Bye]
<azonenberg> So scopehal / ngscopeclient might be getting electronic load support soonish lol
<azonenberg> Just have to decide which one to buy
<azonenberg> and what to move in my lab to make space for it :p
Degi_ has joined #scopehal
Degi has quit [Ping timeout: 248 seconds]
Degi_ is now known as Degi
Stephie has quit [Ping timeout: 248 seconds]
Stephie has joined #scopehal
<josuah> azonenberg: I suppose it will be 19 inch wide?
jevinskie[m] has joined #scopehal
<d1b2> <johnsel> not bad buddy @t4nk_freenode
<d1b2> <johnsel> I do wonder if placing your taps in the middle of that board doesn't influence SI too much? Seems like you're getting awfully near a quarter wave length at 20mhz there
<t4nk_freenode> mmm, hadn't thought of that I must admit
<t4nk_freenode> but I've been messing before with the flying leads, I really don't have much experience with this mind
<t4nk_freenode> but I was unsettled by how it interfered
<t4nk_freenode> so I went with very short leads, and the black lead-ish things in the last picture are resistors; I found that was the way to get them to work with the fx3
<t4nk_freenode> same leads on the fx2 did fail btw, I guess it's because there must already be some there or so
<t4nk_freenode> but I'm back to usb issues now ;)... turns out I really need iommu disabled here
<t4nk_freenode> and then there's the fact that the closed source fx3 driver for sigrok won't let me sample at 100MHz
<t4nk_freenode> I'm supposed to increase the buffer size they said, *sigh*
<azonenberg> josuah: yes, the ultimate goal is a 24x 1GbaseT + 1x 10G SFP switch
<azonenberg> oh wait the load
<azonenberg> (wrong channel lol)
<azonenberg> i just ordered the entry level siglent
<azonenberg> gonna shove it on the back of my bench behind the soldering station because i'm out of racj space
<azonenberg> well ok i have 6U free between the two racks but it's all allocated for gear i'll use more often
<josuah> if only I could use the ceiling and floor for fitting equipment...
<josuah> in my case it might be more about small area than abundance of equipement though
<azonenberg> yeah i have a total of 400 square feet to work with
<azonenberg> but that has to fit the wet bench, the soldering/test bench, the optical microscopy bench, storage, two racks of servers and networking gear, etc
bvernoux has joined #scopehal
Stephie has quit [Ping timeout: 252 seconds]
Stephie- has joined #scopehal
Stephie- is now known as Stephie
bvernoux has quit [Read error: Connection reset by peer]