GNUtoo has quit [Remote host closed the connection]
GNUtoo has joined #u-boot
littlebobeep has joined #u-boot
mmu_man has quit [Ping timeout: 272 seconds]
littlebobeep has quit [Ping timeout: 240 seconds]
littlebobeep has joined #u-boot
littlebobeep has quit [Ping timeout: 240 seconds]
chrfle has quit [Ping timeout: 276 seconds]
chrfle has joined #u-boot
littlebobeep has joined #u-boot
littlebo1eep has joined #u-boot
littlebobeep has quit [Ping timeout: 240 seconds]
camus has joined #u-boot
camus has quit [Ping timeout: 250 seconds]
darkapex has quit [Ping timeout: 256 seconds]
littlebobeep has joined #u-boot
littlebo1eep has quit [Ping timeout: 240 seconds]
littlebobeep has quit [Ping timeout: 240 seconds]
littlebobeep has joined #u-boot
guillaume_g has quit [Quit: Konversation terminated!]
littlebobeep has quit [Ping timeout: 240 seconds]
littlebobeep has joined #u-boot
stefanro has quit [Quit: Leaving.]
littlebobeep has quit [Ping timeout: 240 seconds]
apritzel_ has joined #u-boot
littlebobeep has joined #u-boot
littlebobeep has quit [Ping timeout: 240 seconds]
apritzel_ has quit [Ping timeout: 272 seconds]
littlebobeep has joined #u-boot
littlebobeep has quit [Ping timeout: 240 seconds]
littlebobeep has joined #u-boot
<littlebobeep>
Hi all, I am interested in this device: https://docs.gl-inet.com/en/3/specification/gl-mv1000/ if I want to compile my own u-boot do I need something to connect to those two GPIO pins on the top right of the PCB?
<littlebobeep>
Apparently I can do this: Hold the reset while powering on, until the middle LED light up. You will enter uboot failsafe
<littlebobeep>
But I do not know if failsafe mode does what I want