uartist has quit [Quit: Ping timeout (120 seconds)]
uartist has joined #openocd
Guest9 has joined #openocd
<Guest9>
I finally was able to flash the volatile memory but now i have some trouble flashing the attached flash. iam using this command openocd -f neo.cfg -c "init" -c "jtagspi_init 0 spiOverJtag_xc7a200tfbg484.bit" -c "jtagspi_program sinus.bit 0" but get an "Error: Unknown flash device (ID 0xffffff)"
<Guest9>
are the spi bridges different between different pieces of software or are they universal and just limited to one fpga type?
<PaulFertser>
Guest9: you're not trying just to play back an SVF, why?
jancoow has quit [Ping timeout: 255 seconds]
<Guest9>
oh, i can do that as well. do i need a special command for that? openFPGALoader just crashed when I tried :D
<Guest9>
never mind, found it
<Guest9>
i am a bit scared .. apparently the SVF sets the frequency .... i just bitbanged witha raspberry pi at 6MHz ...
<Guest9>
its still not resetting on startup ... it works right after using the command though. i am at a wits end here :D
<PaulFertser>
Guest9: if Vivado generates that SVF it means it's doing all the same.
jancoow has joined #openocd
<Guest9>
i shall investigate further
merethan_ has joined #openocd
PaulFertser has quit [Ping timeout: 256 seconds]
PaulFertser has joined #openocd
PsySc0rpi0n has quit [Quit: Leaving]
maribu[m] has quit [Quit: You have been kicked for being idle]
loki_val has joined #openocd
crabbedhaloablut has quit [Ping timeout: 255 seconds]
Hawk777 has joined #openocd
wingsorc has joined #openocd
Guest9 has quit [Quit: Client closed]
nerozero has quit [Ping timeout: 255 seconds]
merethan_ has quit [Remote host closed the connection]