GNUmoon has quit [Remote host closed the connection]
GNUmoon has joined #glasgow
Eli2| has joined #glasgow
tec has quit [Quit: bye!]
tec has joined #glasgow
Eli2_ has quit [Ping timeout: 252 seconds]
redstarcomrade has quit [Read error: Connection reset by peer]
cryo1779[m] has joined #glasgow
<cryo1779[m]>
Thanks to all involved for creating the hardware/software and all in between. Now it has arrived I'm trying to get my head around how it all hangs together and works. Moving up from tinkering with my bus pirate i have managed to get memory-24x working but memory-25x is kicking me (I bet its something simple) with no response from the device and low signals i have had to break out my scope. Not sure if this appropriate place but any
<cryo1779[m]>
suggestions or hints for a glasgow noob??
saksham has joined #glasgow
<saksham>
:-/
urja has quit [Read error: Connection reset by peer]
urja has joined #glasgow
saksham has quit [Quit: ok by off to dusshera maidaan to see the effigy of ravan burn]
<cryo1779[m]>
Trying to talk to MX25L6406E, 3V, 64Mb, v1.9 using glasgow -v run memory-25x --port A --pins-cs 5 --pins-io 2,4,3#,0# --pin-sck 1 -V 3.3 identify. Can observe "AB" being sent but nothing else and no response from MX25L6406E, scope is showing signals ~1.5v high and ~0.6v low. Tried following https://vvx7.io/posts/2023/07/glasgow-interface-explorer-reading-spi-flash-memory/ but appears COPI --pin-copi and CIPO --pin-cipo have since been
<cryo1779[m]>
deprecated and replaced with --pins-io.
meklort_ has joined #glasgow
meklort has quit [Ping timeout: 248 seconds]
meklort_ is now known as meklort
redstarcomrade has joined #glasgow
whitequark[cis] has quit [Quit: Idle timeout reached: 172800s]
redstarcomrade has quit [Read error: Connection reset by peer]