09:48 <beerman> finally set up a swap partition for the pi and updating ports

09:49 <beerman> of course it died earlier on llvm without it, woops

10:31 <pitillo> yeah, those ports relay on swap yes or yes

10:31 <pitillo> let's see how it goes with swap

11:06 <pitillo> I'm trying to use 3.6 32b on the M1

11:13 <beerman> is your government okay with this? 😄

11:17 <pitillo> just trying... but prt-get is not working properly (it can't find ports xD)

11:18 <pitillo> the container is a armv7 so it should be fine... but I don't remember if 32b must support arv5 xD

11:19 <beerman> i think it depends

11:23 <pitillo> I believe we were supporting some old > armv5te on the 32b releases...

11:23 <pitillo> so building on the M1 can break it and we'll need to restart the release build on the odroid or cubieboard2

14:47 <beerman> i just noticed that it doesn't clock up and I was using the wrong governor... 😴

16:48 <pitillo> which governor were you using beerman ? and which one are you using now?

16:49 <beerman> dunno which one was being used, now performance

16:49 <pitillo> I use ondemand I believe

16:50 <pitillo> it can scale down if not needed, I believe, and scale up when needed

18:21 <beerman> i'd need to reboot, but it finished llvm and compiler rt already and now its doing aarch64 rust

18:21 <beerman> 4 threads and all

18:24 <pitillo> niiiice

18:24 <pitillo> very good news

18:29 <beerman> 🤓

18:58 <pitillo> I'm out again after trying a kernel 6.1.... bit by bit. Tomorrow I'll check the behavior over serial again

19:06 <beerman> have a nice evening 👋

19:40 <pitillo> same there beerman :D