azonenberg changed the topic of ##openfpga to: Open source tools for FPGAs, CPLDs, etc. Silicon RE, bitfile RE, synthesis, place-and-route, and JTAG are all on topic. Channel logs: https://libera.irclog.whitequark.org/~h~openfpga
Flea86 has quit [Ping timeout: 240 seconds]
Degi_ has joined ##openfpga
Degi has quit [Ping timeout: 256 seconds]
Degi_ is now known as Degi
<somlo> anyone know where I can buy a "cross-over" sata cable?
<somlo> most "normal" cables connect the host-side TX (pins 2,3) to the device-side RX (also pins 2,3), and host-RX (pins 5,6) to device-TX (also 5,6), like in this image: https://imgur.com/a/0MylpuL
<somlo> but the fpga board I just bought has its connector wired up like a "device": https://imgur.com/a/6G8SA1R
<somlo> so I need a cable that connects pins (2,3) <-> (5,6) and (5,6) <-> (2,3)
<somlo> huh, maybe two "normal" cables and one of these: https://www.amazon.com/Pin-Male-Serial-Adapter-Coupler/dp/B017RV8IN0 should work...
Flea86 has joined ##openfpga
Flea86_ has joined ##openfpga
Flea86_ has quit [Client Quit]
Flea86 has quit [Ping timeout: 256 seconds]
kristianpaul has joined ##openfpga
krispaul has quit [Ping timeout: 240 seconds]
kristianpaul has joined ##openfpga
Flea86 has joined ##openfpga
Flea86 has quit [Ping timeout: 240 seconds]
Flea86 has joined ##openfpga
Flea86_ has joined ##openfpga
Flea86_ has quit [Remote host closed the connection]
Flea86 has quit [Ping timeout: 240 seconds]
gurki has quit [Remote host closed the connection]
Flea86 has joined ##openfpga
Flea86 has quit [Quit: Leaving]
unkraut_ is now known as unkraut
sgstair_ has joined ##openfpga
sgstair has quit [Read error: Connection reset by peer]
_sgstair has joined ##openfpga
krispaul has joined ##openfpga
sgstair_ has quit [*.net *.split]
kristianpaul has quit [*.net *.split]
_sgstair is now known as sgstair
Miyu has joined ##openfpga
hackkitten has quit [Ping timeout: 240 seconds]
Miyu has quit [Read error: Connection reset by peer]
hackkitten has joined ##openfpga
gurki has joined ##openfpga