16:22 <vagrantc> i'm trying to do the rough equivalent of $ dd if=$DIR/u-boot.gxbb of=$DEV conv=fsync bs=512 seek=97 ... from within u-boot ... i've managed to load u-boot.gxbb ... but i'm a little unsure of the corresponding mmc write command

16:31 <vagrantc> alternately, any clues about odroid-c2 resetting when loading a kernel? currently stuck on u-boot 2022.07

16:33 <vagrantc> synchronous about ... resetting CPU immediately after trying to boot a kernel https://paste.debian.net/1265171/

17:16 <Tartarus1> vagrantc: OK, I have a hint at least about equiv commands, from my mx6 notes:

17:17 <Tartarus1> dd if=u-boot-with-spl.imx of=/dev/XXX bs=1K seek=1

17:17 <Tartarus1> mmc write ${loadaddr} 2 400

17:17 <Tartarus1> being equiv

17:27 <vagrantc> ok, ... not just perform a few contortions on numbers and ... maybe it works :)

17:27 <vagrantc> er, now just perform...

17:28 <vagrantc> trying to write an old hopefully working u-boot from leftovers laying around

17:32 <vagrantc> so, in your example, the blocks that u-boot assumes are 512 (e.g. 1K = 2 * 512) ? ... so the 2 basically the seek location in dd terms?

17:33 <Forty-Bot> vagrantc: yes

17:33 <vagrantc> and the 400 is how many blocks to write?

17:33 <Forty-Bot> 400 (hexadecimal)

17:33 <vagrantc> eesh.

17:33 <Forty-Bot> I'm not a fan of the implicit hex everywhere, but we can't really change it

17:37 <vagrantc> well, either i botched the command or that wasn't a working u-boot.gxbb image

17:37 <vagrantc> get in a rapid reset loop now

17:37 <vagrantc> will actually have to go dig out that board now :/