<trabucayre>
cr1901: I have to fix behavior when more than one machXO are chained
<cr1901>
I might be able to set that up. Also, FWIW, the machxo2 7000HC board from Lattice exposes the JTAG interface on pins, but I believe you have to desolder some resistors to use it.
<cr1901>
And... I actually can't set that up b/c I'm using the FTDI interface on my 7000HC board right now :/
<trabucayre>
It's not to ask you for the modification :)
<trabucayre>
yes the FTDI may be Ã"disconnected" and/or set in reset mode
<trabucayre>
it's just to know if a board without onboard exist :)