08:11 <effbiai> https://repo.or.cz/ seems to be unavailable for me. is it unavailable for others as well?

08:13 <PaulFertser> effbiai: not available, correct

08:13 <effbiai> makes bootstrapping quite hard :x

08:13 <PaulFertser> effbiai: there's a patch on Gerrit to change official URLs for submodules, it's likely going to be merged this weekend.

08:13 <effbiai> roger

08:13 <PaulFertser> effbiai: yes, sorry, you'd need to change .gitmodule manually

08:14 <effbiai> got a doc for it? i mean.. i don't know all the repo's ruls without googling alot :P

08:15 <effbiai> or maybe a link for the patch?

08:16 <effbiai> should have been on https://review.openocd.org/ or am i wrong?

08:18 <effbiai> found it https://review.openocd.org/c/openocd/+/6834

10:08 <karlp> PaulFertser: just "git submodule set-url blah newurl" is enough surely?

10:08 <karlp> I mena, same thing in the end, but I know the seturl command wasn't there in the old days...

10:11 <PaulFertser> karlp: sure

15:21 <Haohmaru> any new cheap-ish DAP-based SWD debuggers preferably with serial over USB?

15:32 <Haohmaru> otherwise i'll go with this one again: https://kamami.pl/en/stm32-programmers/575534-zl33prg-swd-programmer-debugger-for-arm-core-microcontrollers.html

19:27 <rkta> Before I waist more time, has some here got openocd working to connect to a RPi pico using a jlink or stlink/v3?

19:28 <antto> stlink v3 won't work because it's locked to ST chips

19:28 <PaulFertser> rkta: stlink/v3 certainly not

19:28 <PaulFertser> rkta: jlink should work I guess, do you have any issue with it?

19:32 <rkta> PaulFertser: I could not get it to work today, but I'm not at my desk anymore. Just wanted to know if it's possible at all. I'll try again tomorrow and will come back with more detail if I fail. From what I remember I only had a rp2040_core0.cfg and got some error messages about swd not being supported. Your general yes is enough for me today, thanks. :)

19:32 <PaulFertser> rkta: jlink should be fine for SWD

19:33 <PaulFertser> rkta: just source jlink interface config, then "transport select swd".

19:35 <PaulFertser> rkta: make sure you connect target's Vcc to jlink's Vtref.

19:35 <rkta> will try and report back :)

19:36 <PaulFertser> rkta: good luck :)

19:37 <rkta> We replaced some STM chips with RPi pico, because those were on stock...

20:14 <dmh> brave :D

21:11 <bencoh> oh, I wonder how that rp2040 performs power-wise

21:25 <rkta> it's selling a shitty device vs selling no device :) power doesn't matter, it's powered via usb in an industrial environment

21:26 <rkta> we'll see how it goes